Vol 15, No 1 (2011) > Articles >

Ergonomic Analysis of Garment Industry using Posture Evaluation Index (PEI) in Virtual Environment

Erlinda Muslim 1 , Boy Nurtjahyo 1 , Romadhani Ardi 1

Affiliations:

  1. Departemen Teknik Industri, Fakultas Teknik, Universitas Indonesia, Depok 16424, Indonesia

 

Abstract: This research tried to study, in a virtual environment, the ergonomics of four divisions in garment industry: cutting division, sewing division, button division, and finishing division. Variables that influence the working conditions in each division are different; depend on the real situations that happened. The purpose is to assess the real working conditions based on ergonomics  study  using Posture Evaluation Index (PEI). PEI integrates  the scores of  low back analysis (LBA), ovako working  posture  (OWAS),  and  rapid  upper  limb assessment  (RULA).  Analysis  phase  was  done  using  digital  human model  in  virtual  environment  that  available  on  Jack  6.0.  The  results show  that  the  working  conditions  in  garment industry had enough amount of risk that can injured the musculoskeletal system of the workers. This research enriches the  body  of  ergonomics  knowledge  in Indonesia  because  it  is  the  first  research  in  Indonesia that  applied  virtual environment approach to ergonomics analysis in industry.
Keywords: ergonomics, garment industry, posture evaluation index, virtual environment
Published at: Vol 15, No 1 (2011) pages: 75-81
DOI:

Access Counter: 1978 views, 2564 PDF downloads, .

Full PDF Download

References:

R.S. Bridger, Introduction to Ergonomics, 2nd ed., Taylor & Francis, New York, 2003, p.548.

Ergonomics In The Garment Manufacturing Industry, Work Safe Bulletin, No 188. www.safemanitoba.com/uploads/bulletins/bltn188. pdf. 1997

L. Punnet, Wegman, H. David. J. Electromyography and Kinesiology 14 (2004) 13.

M. Hagberg, P. Buckle, L. Fine, A. Franzblau, Å. Kilbom, E. Menckel, L. Punnett, H. Riihimäki, B. Silverstein, E.V. Juntura, In: P. Seppälä, T. Luopajärvi, H. Nygård, M. Mattila, (Eds.), WMSDs: A Reference Book for Prevention, Taylor & Francis, London, 1997, p.6.

N. Adiputra, A. Manuaba, H. Purnomo, ejournal.unud.ac.id/abstrak/e_journal_hari_purnomo.doc, 2006.

Task Analysis Toolkit (TAT) for Jack. Siemens PLM Software. http://www.siemens.com/plm, 2008.

W. Karwowski, International Encyclopedia of Ergonomics and Human Factor, Taylor and Francis, New York, 2001, p.3299.

L. McAtamney, N. Corlett, Appl. Ergonomics. 1993, p.91.

R. Kalawsky, The Science of Virtual Reality and Virtual Environments. Gambridge: Addison Wesley Publishing Company, Wokingham, UK, 1993, p.396.

D.T. Pham, A. Ghanbarzadeh, E. Koc, S. Otri, M. Zaidi, 2nd I* PROMS Virtual International Conference 3/14 (2006) 425.

M. Tlauka, Computers in Human Behavior 23 (2007) 515.

I.D. Bishop, J.R. Wherrett, Landscape and Urban Planning 52 (2001) 225.

UGS The PLM Company, E-Factory JACK 2004, http://www.plm.automation.siemens.com/en_us/about_us/newsroom/press/press_release.cfm?Component=25686&ComponentTemplate=822, 2009.

F. Caputo, G.D. Gironimo, A. Marzano, Acta Polytechnica 46 (2006) 22.

G.D. Gironimo, G. Monacelia, S.A. Patalano, International Design Conference–Design, Dubrovnik, 2004, p.4.