Vol 14, No 1 (2010) > Articles >

Maintenance Activity Planning by Reability Centered Maintenance II Method

Rachmad Hidayat 1 , Nachnul Ansori 1 , Ali Imron 1


  1. Jurusan Teknik Industri, Universitas Trunojoyo, PO BOX 2 Kamal Bangkalan, Madura 16912, Indonesia



This research discuss maintenance activity by using RCM II method to determine failure function risk at compresor screw. Calculation is given to magnitude optimum time maintenance interval by considering the cost maintenance and the cost reparation. From the research results with RPN points out that critical component that needs to get main priority in give maintenance on compresor screw are bust logistic on timeworn piston, and on filter's sponge airs to come out damage that gets RPN 45. Optimum maintenance interval point one that acquired to prevent failure on compresor screw smaller than appreciative MTTF which indicate optimum maintenance interval in avoiding its bust happening logistic component before happening damage.

Keywords: compresor screw, maintenance activity schedule plan, optimum time maintenance interval, RCM II, risk assessment
Published at: Vol 14, No 1 (2010) pages: 7-14

Access Counter: 2422 views, 2 Untitled downloads, 10907 PDF downloads, .

Full PDF Download


J. Moubray, Introduction Reliability Centered Maintenance,International Edition, Industrial Press Inc., New York, 2001, p.135.

I. Setyana, Tugas Akhir,Jurusan Teknik Industri, FTI, Institut Teknologi Sepuluh November, Indonesia, 2007.

R.T. Anderson, L. Neri, Reliability Centered Maintenance: Management and Engineering Methods, Elsevier Science Publishers Ltd., New York, 1990, p.122.

B.S. Dhillon, Engineering Maintenance: A Modern Approach, CRC Pres LLC, N.W. Corporate Blvd., Boca Raton, Florida, 2007, p.153.

B.T. Cahyono, Manajemen Produksi, IPWI, Jakarta, 2005, p. 115.

M.P. Tampubolon, Manajemen Operasional, Ghalia Indonesia, Jakarta, 2004, p.98.

D. Berger, Advanced Failure Analysis Methodologies and Techniques, http://www.plantservices.com/articles/2007/073.html?page=print, 2007.

Anon., Reliability Centered Maintenance, Det Norske Veritas (DNV) Managing Risk, www.dnv.com, 2006.

A.M. Smith, G.R. Hoinchcliffe, Reliability Centered Maintenance, McGraw-Hill Inc., New York, USA, 2004, p.223.

Jamasri, C.A. Pinto, Prosiding Seminar Nasional Industrial Service, Teknik Industri, Universitas Sultan Ageng Tirtayasa, 2009, p.III-151.

B.S. Blanchard, D.Verma, E.L. Peterson, Maintainability, John Wiley & Sons Inc., New York, 1994, p.127.

C.E. Ebeling, An Intruduction to Reliability and Maintainability Engineering, The McGraw-Hill Companies, Inc., New York, 1997, p.23.

A. Stagliano, A. Rath, Strong’s Six Sigma Advanced Tools Pocked Guide, ANDI, Yogyakarta, 2005, p.29.

Haryono, Perencanaan Suku Cadang berdasarkan Analisis Reliabilitas, Laporan Penelitian, Jurusan Statistika, FMIPA, Institut Teknologi Sepuluh November, Indonesia, 2004.