Vol 15, No 2 (2011) > Articles >

Improvement of High Temperature Oxidation of Low Carbon Steel Exposed to Ethanol Combustion Product at 700 °C By Hot-Dip Aluminizing Coating

Mohammad Badaruddin 1


  1. Mechanical Engineering Department, Lampung University, Bandar Lampung 35145, Indonesia



Low carbon steel (AISI 1005) was coated by hot-dipping into a molten Al-10% Si bath at 700 °C for 18s. After hotdipping treatment, the coating layers consisted of Al, Si, FeAl3, τ5-Fe2Al8Si, and Fe2Al5. The bare steel and the aluminized steel were isothermally oxidized at 700 °C in ethanol combustion product at atmospheric pressure for 49 h. The aluminized steel shows good performance in high temperature oxidation because the formation of Al2O3 layer on the coating surface. The growth of iron oxide nodules on the surface coating was accelerated by rapid outward diffusion of Fe-ions due to the presence of H2O-vapour generated by ethanol combustion. Thus, the oxidation rate of aluminized steel increased, resulting in a substantial mass-gain as the oxidation time increased. After longer exposure, the τ1-(Al,Si)5Fe3 phase was completely transformed to the FeAl in the outer layer. The FeAl formed near the steel substrate was due to Fe-atoms diffusing into the Fe2Al5 layer when the time and temperature increased.

Keywords: aluminized steel, ethanol combustion product, low carbon steel
Published at: Vol 15, No 2 (2011) pages: 137-141

Access Counter: 1252 views, 787 PDF downloads, .

Full PDF Download


A. Szklo, R. Schaeffer, F. Delgado, Energy Policy 35 (2007) 5411.

Z. Sahin, O. Durgun, Energy Fuels 23 (2009) 1707.

Y.H. Yoo, I.J. Park, J.G. Kim, H. Kwak, W.S. Ji, Fuel. doi:10.1016/j.fuel.2010.10.058.

R.Y. Chen, W.Y.D. Yuen, Metallur. Mater. Trans A. 40 (2009) 3091.

H.T. Abuluwefa, R.I.L. Guthrie, F. Ajersch, Metallur. Mater. Trans A. 28 (1997) 1633.

L. Sánchez, F.J. Bolívar, M.P. Hierro, F.J. Pérez, Thin Solid Films 517 (2009) 3292.

M. Yoshihara, S. Taniguchi, T. Kubota, J. Japan Inst. Metal. 71 (2007) 16.

S. Taniguchi, N. Hongawara, T. Shibata, J. Japan Inst. Metal. 62 (1998) 542.

C.J. Wang, M. Badaruddin, Surf. Coat. Technol. 25 (2010) 1200.

M. Badaruddin, Ph.D Thesis, College of Engineering, National Taiwan University of Science and Technology (NTUST), Taiwan, 2011.

W.J. Cheng, C.J. Wang, Surf. Coat. Technol. 204 (2009) 824.

Y.A. Chang, L.M. Pike, C.T. Liu, A.R. Bilbrey, D.S. Stone, Intermetallics 1 (1993) 107.

H. Xiao, I. Baker, Scripta. Metall. Mater. 28 (1993) 1411.

W.J. Cheng, C.J. Wang, Mater. Charact. 61 (2010) 467.